Surfbent Windsurf Board Protector
The Protector
In the event of an uncontrolled fall of the rig or in extreme situations such as a spin crash, the rig first hits the protector. During this contact, the resulting energy is dissipated by deformation of the power joint (material elastomer). In this way, the entire board can be protected better.
2-pin systems
Prepared for mounting with 1-pole and 2-pole mast bases.
Deck Protection Pad
The deck protection pad (silicone rubber) protects the delicate deck surface between the WBP and the surfboard.
Included in the standard set.
340 grams
An optimized, geometric design and simulation of the design structure saved material and reduced weight while achieving the required strength and function.
Compatible with mast bases up to D=122 mm
All common mast bases up to 122 mm diameter can be mounted through the generously dimensioned mounting surface of the protector.
Central weight distribution
The mass of the protector is located close to the center of gravity of the board compared to other solutions and thus has little impact on balance and performance.
Cool, subtle design
An eye-catcher thanks to the harmoniously chosen shape combined with a fancy color choice give your board that certain something.
Installation on all common boards
At the mast base, the friction disc is replaced by the protector and installed as usual.
Suitable for Freestyle
Freestyle maneuvers are not affected by interfering contours caused by geometry.
Unrestricted trim
Adjustment range of the mast track remains unchanged.
Assistance with water start
The water start is made easier by the shape of the protector and the resulting lift-up effect (lifting the sail towards the starting position).
Simplified handling
Handling in the water is hardly affected by the flowing shape.